Saturday, November 5, 2011

Constructing a 6" CQ block

One of my ongoing projects if my flower quilt.  Here's one block that's completed to give you an idea of the size and construction.  Total size of the block is 8" square, but I only embroider 6" square.  The blocks all have a green centre and a flower.  The colour of the flower determines the outer fabric.  In this case shades of rust and orange.


I found a couple of really nice flowers on clearance. They are a little bigger than those I have already used, but they have fabric and lace petals and I could trim them later if I need to.
For this tutorial I will be using the pale green lace flower.
Here is the 8" muslin square.  I have marked the corners of the 6" square embroidery area.  I cut out a six sided piece of the green fabric and placed it in the centre.


Next I took pieces of green fabric to  blend with the green flower and laid them on three sides of the centre piece.  I tested it out with my cardboard frame.  

I carried on around the centre piece's six sides laying out fabric of my choice.  The final sixth piece of fabric was tucked under the first piece.


I tested to see if the flower looked OK. To begin sewing, gently pull out the muslin block from the centre , leaving the six fabrics in place.
Next, beginning with one of the six fabrics, lay it right sides together along one of the centre sides.  Sew only the length of the centre side, marked here with pins.

This photo shows the right side.  Press the seam flat.  I have  lined up my ruler with the second centre edge and drawn a straight lined across the first fabric.  Cut on that line, turn the block over and trim any overhanging fabric.

This is the block now.  First piece of fabric sewn down, pressed, trimmed.  Note that the first fabric that overlaps the muslin is not sewn down.  The last fabric will be tucked under this flap.

Second fabric lined up on second side of centre to the edge of the block.

Here's the second fabric sewn, pressed and marked for cutting.
This is the third fabric. 

Third fabric sewn and pressed.  Just a note to say that it makes a big difference to the finished block when you iron each seam.

Here is the third fabric sewn and the trimming line marked on the front.

Turn the block to the back and trim off the excess fabric. 

Carry on adding your fabric pieces,  sew and press, then trim.  Here five pieces of fabric are in place.

Here is the block ready to take the sixth piece of fabric.  The loose first piece of fabric is pinned back so that I can sew a little past the end of the centre block side.

This is the sixth piece pinned down ready to sew.

The sixth piece has been sewn down and I extended it about 1" beyond the end of the centre side.


Everything is sewn except that small pinned section where the sixth fabric was tucked under the first fabric.  I can either hand stitch this down, or machine top stitch with a big stitch that can be unpicked later.



The cardboard frame marks the sewing area.  The cardboard frame works very well.  This one is 8" x 8" on the outside, with 6" x 6" inside measurement. It was made especially for this series of flower blocks. 

Next I would machine a sewing line close to the edge to stop fraying, and then handstitch around the square on the 6" x 6" measurement.  

1 comment:

Cathy said...

Thanks for the tutorial, Diane. You are so organized. I like your cardboard cutout. I never thought of that. I have a quilt template with a cutout middle that would work perfectly, I think. - Cathy L